Everything below concerns mass spectrometry. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-01-21. Numbers and descriptions here follow the published literature rather than marketing material.
Characterization of Selank in laboratory settings relies on standard peptide analytical techniques. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities and degradation products, while mass spectrometry confirms molecular identity through accurate mass measurement. Amino acid analysis and peptide sequencing verify the primary structure when reference material is unavailable. Because Selank is a short chain, fragmentation-based analysis produces a diagnostic ion pattern that supports confident identification.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres is the standard purity method. Mass spectrometry, typically electrospray ionisation, confirms identity through the expected mass-to-charge pattern. Amino acid analysis can verify composition independently. Chiral purity requires separate techniques such as derivatisation followed by chromatographic separation, and such data are rarely reported for research-grade material.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | -20 °C or below | For lyophilized powder, long term |
| Common analytical method | Reverse-phase HPLC | Usually paired with mass spectrometry |
| Typical reported purity | At or above 95 percent by area | Research-grade material |
| Aqueous solubility | High | Solutions used in laboratory assays |
| Moisture sensitivity | Hydrolyzes in solution | Aseptic handling reduces degradation |
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
== Safety == Although argon is non-toxic, it is 38% more dense than air and therefore considered a dangerous asphyxiant in closed areas. It is difficult to detect because it is colorless, odorless, and tasteless. A 1994 incident, in which a man was asphyxiated after entering an argon-filled section of oil pipe under construction in Alaska, highlights the dangers of argon tank leakage in confined spaces and emphasizes the need for proper use, storage and handling.
==== Vitamin B12 ==== Metformin treatment has been associated with reductions in vitamin B12 in certain people. Left untreated, vitamin B12 deficiencies can lead to serious health problems including neurological problems and anemia. Although more research is needed to understand the mechanisms of this association, it is suggested that people who take metformin monitor their vitamin B12 levels and if low, begin supplementation. In most cases of deficiencies if the person's deficiency can be corrected with exogenous administration of vitamin B12, they can continue their metformin treatment.
==== Biosynthesis ==== The biosynthetic route is based on the alkylation of the amino acid tryptophan with dimethylallyl diphosphate (isoprene derived from 3R-mevalonic acid) giving 4-dimethylallyl-L-tryptophan which is N-methylated with S-adenosyl-L-methionine. Oxidative ring closure followed by decarboxylation, reduction, cyclization, oxidation, and allylic isomerization yields D-(+)-lysergic acid. The biosynthetic pathway has been reconsituted in transgenic baker's yeast.
Sources: en.wikipedia.org
Anise tea, made from either the seeds or the leaves Asiatic penny-wort leaf, in South Asia and Southeast Asia Artichoke tea Commiphora gileadensis tea, in the Hijaz region of western Arabia. Bael fruit tea Barley tea, East Asian drink with roasted barley Bee balm Boldo, used in South America Burdock; the seeds, leaves, and roots have been used Butterfly pea flower tea (from Clitoria ternatea), also called "Blue tea" since it produces a blue infusion Caraway, tea made from the seeds Catnip, tea used as a relaxant, sedative, and to calm Chamomile, both Matricaria chamomilla and Chamaemelum nobile can be used Che dang, bitter tea made from Ilex causue leaves Chinese knotweed tea Chrysanthemum tea, made from dried flowers Cinnamon tea Clover tea, made from the blossoms Cerasse, bitter Jamaican herb Citrus peel, including bergamot, lemon and orange peel Dandelion coffee, which does not contain caffeine despite the name Dill tea Dried lime tea, made from dried limes common in western Asia Echinacea tea Elderberry European mistletoe (Viscum album), (steep in cold water for 2–6 hours) Essiac tea, blended herbal tea Fennel Gentian Ginger tea, made from the ginger root, can be made into herbal tea, known in the Philippines as salabat Ginkgo biloba Ginseng tea, a common tea in China and Korea, commonly used as a stimulant and as a caffeine substitute Goji berry tea Hawthorn Hibiscus tea (often blended with rose hip), a common tea in the Middle East or Asia Honeybush, similar to rooibos and grows in a nearby area of South Africa, but tastes slightly sweeter.
In the heart it can cause myocardial infarction In the brain, it can cause a transient ischemic attack (TIA), and, in prolonged blood obstruction, stroke. Blockage of arteries that supply arms or legs may result in necrosis and gangrene Temporary or permanent decrease or loss of other organ functions In septic embolism, there can be infection of the affected tissue or even septic shock, potentially leading to gangrene and sepsis
Looking Glass (or Operation Looking Glass) is the historic code name for an airborne command and control center operated by the United States. Since 2016 it has been referred to as the ABNCP (Airborne National Command Post). It provides command and control of U.S. nuclear forces in the event that ground-based command centers have been destroyed or otherwise rendered inoperable. In such an event, the general officer aboard the Looking Glass serves as the Airborne Emergency Action Officer (AEAO), and by law assumes the authority of the National Command Authority and could command execution of nuclear attacks. The AEAO is supported by a battle staff of approximately 20 people, with another dozen responsible for the operation of the aircraft systems. The name Looking Glass, which is another name for a mirror, was chosen for the Airborne Command Post because the mission operates in parallel with the underground command post at Offutt Air Force Base.
Along with what is seen above, other reactive forms of FAD can be formed and consumed. These reactions involve the transfer of electrons and the making/breaking of chemical bonds. Through reaction mechanisms, FAD is able to contribute to chemical activities within biological systems. The following pictures depict general forms of some of the actions that FAD can be involved in. Mechanisms 1 and 2 represent hydride gain, in which the molecule gains what amounts to be one hydride ion. Mechanisms 3 and 4 radical formation and hydride loss. Radical species contain unpaired electron atoms and are very chemically active. Hydride loss is the inverse process of the hydride gain seen before. The final two mechanisms show nucleophilic addition and a reaction using a carbon radical.
Sources: en.wikipedia.org
The most common approach combines reverse-phase liquid chromatography with mass spectrometry. Chromatography separates the components while mass spectrometry confirms the molecular mass. Peptide sequencing or tandem mass analysis can further verify the amino acid order.
Lyophilized powder is usually kept frozen and protected from moisture. Solutions are less stable and are often used promptly or divided into aliquots to avoid repeated freeze-thaw cycles. Exact shelf-life values depend on purity and handling.
No. A purity figure derived from chromatographic area does not prove the amino acid sequence. Identity requires an orthogonal method such as mass spectrometry or sequencing. Truncated or isomerized peptides can co-elute with the target compound.
Dry powder is best kept sealed, protected from light, and held at minus 20 degrees Celsius or below. Desiccant packaging helps limit moisture uptake because the material is hygroscopic. A sealed vial should be allowed to equilibrate to room temperature before opening to reduce condensation.