The short version of Tuftsin analog fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-11-21. Anything still debated is marked as such rather than presented as settled.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
| Property | Value | Notes |
|---|---|---|
| Solubility | Freely soluble in water | Also in aqueous buffers |
| Typical purity (HPLC) | 95 percent or higher | Lot-dependent |
| Dry powder storage | Minus 20 degrees Celsius | Sealed, dry, protected from light |
| Solution storage | 2 to 8 degrees Celsius | Short-term use |
| Identity confirmation | Mass spectrometry | ESI or MALDI-TOF |
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Proposed mechanisms center on modulation of the GABA system, but no single molecular target has been confirmed. Rodent studies report changes in GABA-A receptor expression and in the turnover of serotonin, dopamine, and norepinephrine in several brain regions. Increases in brain-derived neurotrophic factor and its receptor have also been described after repeated administration. These findings come largely from animal models, and the degree to which they describe human neurochemistry remains an open question. The mechanism is best characterized as multi-system and not fully resolved.
Pharmacokinetic data are limited. Like most short peptides, Selank is vulnerable to plasma and tissue peptidases, and its measured half-life in circulation is short, on a minutes scale. The Pro-Gly-Pro tail slows this degradation but does not eliminate it. Intranasal administration is the route described in most reports, with absorption through the nasal mucosa and a hypothesized path into the central nervous system that avoids the blood-brain barrier. Direct measurements of human brain exposure are unavailable, so distribution claims rest on inference from animal work.
Selank is a synthetic heptapeptide developed in Russia during the 1990s. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences designed it as a stabilized analog of tuftsin, a naturally occurring immunomodulatory tetrapeptide. The compound has been studied primarily for its reported anxiolytic and nootropic effects. It remains largely unknown in Western pharmacology and is not approved as a medicine by major regulators such as the FDA or the EMA.
The primary structure of Selank is Thr-Lys-Pro-Arg-Pro-Gly-Pro, corresponding to the molecular formula C33H57N11O9 and a monoisotopic mass of roughly 751.9 daltons. The N-terminal threonine and the arginine residue in the fourth position are shared with tuftsin, which carries the sequence Thr-Lys-Pro-Arg. The three additional residues at the C-terminus, Pro-Gly-Pro, extend the chain and are associated with greater resistance to enzymatic degradation. This extension also separates Selank from the shorter parent peptide.
Prior to the development of intradialytic parenteral nutrition in the late 20th century, nutritional management of patients receiving dialysis primarily relied on dietary counselling, liberalized renal diets, and oral nutritional supplements; however, protein–energy wasting (PEW) remained common among patients undergoing maintenance hemodialysis. Efforts to supplement nutritional intake by providing nutrients during the dialysis procedure were attempted. As a result, IDPN became an established therapy to threat malnourished CKD stage 5 dialysis patients in the early 1990s. Generally, the patients received a set formulation containing standard amounts of dextrose, amino acids and lipids regardless of the patient's weight, dialysis time, and complicating co-morbid conditions.
The post-bioprinting process is necessary to create a stable structure from the biological material. If this process is not well-maintained, the mechanical integrity and function of the 3D printed object is at risk. To maintain the object, both mechanical and chemical stimulations are needed. These stimulations send signals to the cells to control the remodeling and growth of tissues. In addition, in recent development, bioreactor technologies have allowed the rapid maturation of tissues, vascularization of tissues and the ability to survive transplants. Bioreactors work in either providing convective nutrient transport, creating microgravity environments, changing the pressure causing solution to flow through the cells, or adding compression for dynamic or static loading. Each type of bioreactor is ideal for different types of tissue, for example compression bioreactors are ideal for cartilage tissue.
Essentially all of the studies on 5-oxo-ETE's activities and target cells, similar to those on other members of the 5(S)-HETE family of agonists, are best classified as pre-clinical development studies: they have not yet been determined to be important in human pathophysiology. Translation studies are needed to learn if the preclinical studies implicating 5-Oxo-ETE and other 5(S)-HETE family members in allergic diseases, inflammatory diseases, cancer, steroid production, bone remodeling, parturition, and other pathophysiological events, as outlined here and on the 5-HETE page, are relevant to humans and therefore of clinical significance.
Sources: en.wikipedia.org
The species A. maxima and A. platensis were once classified in the genus Spirulina. The common name, spirulina, refers to the dried biomass of A. platensis, which belongs to photosynthetic bacteria that cover the groups Cyanobacteria and Prochlorophyta. Scientifically, a distinction exists between spirulina and the genus Arthrospira, for which the two species were originally proposed. Species of Arthrospira have been isolated from alkaline brackish and saline waters in tropical and subtropical regions. Among the various species included in the genus Arthrospira, A. platensis is the most widely distributed and is mainly found in Africa, but also in Asia. The term "spirulina" (without italicizing and usually without capitalization) remains in use for historical reasons. In 2019 it was found that the cultivated species differ too much from the type species of Arthospira to be in the genus, necessitating another batch of renaming to Limnospira to reflect biological reality.
The role of the other BDNF receptor, p75, is less clear. While the TrkB receptor interacts with BDNF in a ligand-specific manner, all neurotrophins can interact with the p75 receptor. When the p75 receptor is activated, it leads to activation of NFkB receptor. Thus, neurotrophic signaling may trigger apoptosis rather than survival pathways in cells expressing the p75 receptor in the absence of Trk receptors. Recent studies have revealed a truncated isoform of the TrkB receptor (t-TrkB) may act as a dominant negative to the p75 neurotrophin receptor, inhibiting the activity of p75, and preventing BDNF-mediated cell death.
There are three amino acids with side chains that are cations at neutral pH: arginine (Arg, R), lysine (Lys, K) and histidine (His, H). Arginine has a charged guanidino group and lysine a charged alkyl amino group, and are fully protonated at pH 7. Histidine's imidazole group has a pKa of 6.0, and is only around 10% protonated at neutral pH. Because histidine is easily found in its basic and conjugate acid forms it often participates in catalytic proton transfers in enzyme reactions.
Sources: en.wikipedia.org
Reverse-phase HPLC is the usual method and gives a percentage purity value. Mass spectrometry then confirms the molecular mass. Together they provide a basic identity and purity profile for a lot.
Freeze-dried material is kept frozen, often at minus 20 degrees Celsius, and protected from light and moisture. Dissolved peptide is refrigerated for short-term use. Repeated freeze-thaw cycles are avoided.
A certificate of analysis typically lists purity by HPLC, the confirmed mass, appearance, and sometimes water or counter-ion content. It documents results for a specific batch. Details vary by supplier.
The sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter code. It combines the tetrapeptide tuftsin with a carboxyl-terminal Pro-Gly-Pro extension. This full sequence identifies the molecule more precisely than the research name.